Underfloor Heating
Installation London
Wet underfloor heating systems for new builds and retrofits across London. The most comfortable, efficient way to heat your home — installed to the highest standard.
"Over the moon with our new underfloor heating system and boiler. Top service by DGN."
Heat that rises from
the ground up
Underfloor heating warms the floor surface evenly across the entire room — creating a consistent, gentle warmth that radiates upward naturally. No cold spots, no draughts, no hot air concentrated at the ceiling.
DGN GAS installs wet underfloor heating systems across London — for new builds, extensions, renovations and retrofits. Several of our customers specifically chose DGN GAS after seeing the quality of our underfloor heating work.
Pipework laid
with precision
Continuous pipe runs set out across the floor on a castellated panel system — set evenly into the panel and pressure‑tested before screeding, so the finished floor heats consistently across every room.


Built around the
right systems
For our low‑temperature, whole‑home underfloor heating projects we work with specialist, high‑quality manufacturers — so every system is designed to run efficiently from the outset.

New builds, extensions
& retrofits
New Build & Extension UFH
The ideal time to install wet underfloor heating is during a new build or extension — before the screed goes down. We work alongside your other trades to ensure installation at the right stage.
Retrofit UFH
Underfloor heating can be retrofitted into existing properties using low-profile systems that sit above the existing floor — minimising height increase. Ideal for renovations and room conversions.
Underfloor heating
in an extension
An extension is the easiest time to fit wet underfloor heating, because the floor is being built anyway.
We start by working out the heat loss for the extension room by room, so the pipe spacing and the number of loops match what each space needs. That depends on the insulation, so we ask your builder or architect what is going under the screed and how thick it will be.
The pipes go down on the insulation once the walls are up and before the screed, so we agree the date with your builder well ahead. If there is a gas hob going into the new kitchen, we bury the gas pipe below the celotex and any ufh pipes at the same stage.
Before any screed goes down we pressure test every loop, so a damaged pipe shows up while it can still be put right.
The manifold goes somewhere you can get to, usually a utility or understairs cupboard, with a thermostat for each zone, and then we connect it to your boiler. Most modern boilers can run an extension's underfloor heating, but if the extension adds a lot of heat demand or another bathroom, we check the boiler and the hot water can keep up before we quote and tell you if they cannot.
Then on a winter morning you walk across the new kitchen floor barefoot, with warm feet on the tiles.
It works on a whole house too. In Gerrards Cross we fitted underfloor heating on all three floors of a four-bedroom, three-bathroom house, with two zones on the ground floor around the open-plan kitchen, four on the first floor and one on the top floor, all run from a Vaillant system boiler with a Megaflo cylinder.
Works with most
floor types
Stone & Tile
The best conductor of heat. Heats up quickly and retains warmth — the most popular choice.
Porcelain
Similar properties to stone. Widely used with wet underfloor heating systems.
Engineered Wood
Specifically designed to work with UFH. Ensure the product is rated for underfloor heating use.
Vinyl & LVT
Modern luxury vinyl tiles work well with underfloor heating. Check manufacturer temperature ratings.
Carpet
Can be used but insulates against heat. Lower tog-rated carpets work best with careful system design.
Solid Wood
Can be used with care and controlled temperature settings. We'll advise on your specific flooring choice.
Recent underfloor
heating installations
Gerrards Cross, SL9
Wet underfloor heating with a Vaillant ecoTEC plus system boiler and a Megaflo unvented cylinder, October 2026.
Ealing
Underfloor heating with a Vaillant system boiler, a Megaflo unvented cylinder and an accumulator tank to boost the water pressure.
Wembley
Underfloor heating with a Worcester Bosch system boiler, an unvented cylinder, a mains pressure boost system and air conditioning.
From survey to
a warm floor
Survey & System Design
We survey the space, assess heat loss and design the right UFH layout — pipe spacing, zone layout and manifold placement.
Quote & Planning
Detailed quote covering all materials and labour. We coordinate with your other trades if part of a larger project.
Pipe Installation
Pipes laid in a precise pattern across the floor area. Manifold installed and connected.
Pressure Testing
Before any screed or flooring goes down, we pressure test the entire system to confirm there are no leaks.
Connection & Commissioning
Connected to your boiler or heat pump, thermostats and zone controls installed, system balanced and handed over.
Get in Touch
Free, no-obligation quote
Common questions about
underfloor heating
Do you install underfloor heating?
What's the difference between wet and electric underfloor heating?
Can underfloor heating be added to an existing home?
How much does underfloor heating cost?
Does underfloor heating work with my existing boiler or a heat pump?
"I have had a heating system including a Vaillant boiler, Megaflo and underfloor heating installed by DGN GAS. A very professional service and am extremely happy. I especially like the after sales care. Would highly recommend."
"Over the moon with our new underfloor heating system and boiler. Top service by DGN."
Planning underfloor heating?
Call us to discuss your project — new build, extension or retrofit. London-wide coverage.
Get a Quote 07813 474638